richies rig updated loads of pics

[Xtreme tweaker/builder]

hi guys sorry its taken so long to get back to it

only a few things left now

2 xfx 8800 ultra xxx missing

qx6850 missing

dominator ram missing but everything else on the list is there

 

[Xtreme tweaker/builder]

more pics

and more

 

[Xtreme tweaker/builder]

and more

 

[Xtreme tweaker/builder]

last one

still got a bit of cable tidying to do a couple of rhoebus's to make but not to bad so far

 

[Xtreme tweaker/builder]

nobody got anything to say

 

[FarFarAway]

I think the watercooling and internals are nice, but I'm not a huge fan of some of the externals. Still, a pretty clean install

 

[mrapoc]

Was it easy to mount the rad to the top? How so?

 

[Xtreme tweaker/builder]

kempez do you mean the chrome dragons and fire decals how about the fan and western digital raptor blowhole decals can be removed no problems will be a lot cleaner when the graphics cards go in

mrapoc the top radiator was the easiest thing to do first i madea template of the pa120.2 radiator (peice of tracing paper and a pencil ) then used masking tape to hold it down while i dremmelled out two fan shaped holes , two rectangles for the 1/2" fittings and 8 screw holes attached the thermochill gasket to the radiator mounted that on top of the mesh then on the inside mounted two silversone tech fm121b's with silicone vibration dampners on the inside in a push configuration

 

[Yeungster]

I'm impressed!

Just a couple of questions though:

1) The tubing going in and out of the fuzion looks kinked. I assume they're not?

2) Is the HDD thats stuck on the side going to be held on with sticky tape permanently? I'd be scared of it falling off and breaking, thats all

Love the way triple rads sit in the bottom perfectly!

 

[Xtreme tweaker/builder]

Yeungster thankyou

1. no the tubing is not kinked but will be adding some spirals to the ends to make sure will try to take a photo from a different angle so you can see

2. the raptor x is held flat down using heavy duty cable ties and zip tie blocks with unibonds metal adhesive on the back there are 2 blocks on each corner now able to hold 50 kg each lol

the tj07 is massive the rad sits between four rubber pads each side on top and long rubber pads along the bottom

thanks