Kempez's Project <<| Black3d |>> **56k**

DON'T GO WITH BLUE!!!!!!!!!!!!! Everyone does blue and it is pretty annoying to see every single computer have blue leds and such. Well just my .02 you can do whatever you want :)
 
The comp looks like it's coming right along kemp :) Definately some nice choice of parts, I miss my PC-75B... Easily one of the greatest cases of all time, if not THE greatest. Roomy, sexy, precise. Lian Li.

Why didn't u pick up a DD full cover block Kemp? They have uber nice finishes and cool very well.
 
Cause ST got me the Alphacool very cheap. Plus it looks nice ;)

I may get another block depending on performance - but I think I'll be pretty happy with it :)
 
those look like some good high flow low restriction elbows. ya gotta watch out for the elbows that get smaller in diameter in the middle, those will hurt ur flow quite a bit.
 
If you end up going for a different full-cover block, Eddy EK's seem to be main favorites. Don't give too much of a perfomance hit compared to a "normal" block like the MCW60 or Maze4
 
Actually the maze4gpu provides very little of a hit to the loop. The mcw60 has less of a hit than the EK's also.

I think yuor confusing flow and restriction.
 
NoL said:
Actually the maze4gpu provides very little of a hit to the loop. The mcw60 has less of a hit than the EK's also.

I think yuor confusing flow and restriction.

Umm dude... that's exactly what I'm saying man... I'm saying full-cover are typically considered worse, but out of them, EK's are favored.
 
Dodgy as hell dry test loop. Doesn't look too bad and at least it all fit in ;)



Decided against the elbow in the pumps/res



Put some plumbers tape on the barbs



Then fitted them :)



 
Nice looking so far Kemp. One question...why the different tubing? Some of it is completely transparent yet some isn't. Any specific reason on that?
 
Lookin' good so far mate! When ya gonna get the water in her?

And I must ask why you have an elbow going in to your cpu block? It looks 110% un necessary.
 
The elbow is in there cause its a very tight fit. I may try to get it out though

@twisted: Some of the Tubes are used and some are new. The final build will be with all new tubing :)

Water is going in when I get the Alphacool block :)
 
Back
Top