Burning in BH5 - need help

[The Legend]

Please help me,

I am burning in some BH5 and I am now at 269mhz with failures only on test 8 (30 or so per pass).

To burn in faster does it help, knowing that I only get errors on one test to just burn that test until the errors go away?

Any experienced RAM burners that can help would be appreciated.

 

[maverik-sg1]

I run through all the tests - not because it's the best way coz I really dont know - just because thats the way I have always done it.

LivingL@rge, Gollum and Dazboots might be able to tell you a bit more.

The Coach

 

[stocky]

I thought test 5 was the best, with minimal errors?

Also allowing to heat up, then cool down quickly is meant to help...

 

[Dazboots]

I thought test 5 was the best, with minimal errors?

Also allowing to heat up, then cool down quickly is meant to help...

thats right m8 test 5 is very stressfull and test 8.......

to burn in memory run 200 fsb@2-2-2-5 3.2 volts run test 5 for about 12 hours.........

then run test 8 12 hours same settings..............

after that it should be able to go higher with less volts and less errors in memtest.........

hope this helps m8....

ps make sure u have good air flow on memory @ all times.....

 

[unreal]

thats right m8 test 5 is very stressfull and test 8.......

to burn in memory run 200 fsb@2-2-2-5 3.2 volts run test 5 for about 12 hours.........

then run test 8 12 hours same settings..............

after that it should be able to go higher with less volts and less errors in memtest.........

hope this helps m8....

ps make sure u have good air flow on memory @ all times.....

Aye with 3.2v you want a fan on it.

Also with the DFI you want a fan on top right mosfet.