OK I have installed raid on on asrock but now I cant see my old drives - raid 0 is on two WD250GB SATA2, old drives are are on IDE 120 and 80 GB Seagate's.
First - as of now I'm running on old drives again array broken and have wiped drives clean.
2) when I set up the array it was supposed to be sata2 but I'm pretty sure it ran in sata1 only ( using floppy to install drives sata 2 ones keep failing)
So how do I get SATA2 working in raid 0 and also be able to see my old drives, I saw some one has said on another board that when installing sata2 you do not push F6 but put in floppy just as Windows starts to boot? is this true?.
ANY HELP WOULD BE APPRECIATED
First - as of now I'm running on old drives again array broken and have wiped drives clean.
2) when I set up the array it was supposed to be sata2 but I'm pretty sure it ran in sata1 only ( using floppy to install drives sata 2 ones keep failing)
So how do I get SATA2 working in raid 0 and also be able to see my old drives, I saw some one has said on another board that when installing sata2 you do not push F6 but put in floppy just as Windows starts to boot? is this true?.
ANY HELP WOULD BE APPRECIATED