Prommy front panel

[Smiffy]

Hi Guys

At long last i've got my Prometia GT up and running.At the mo an XPM at 2600Mhz on 1.70v.Little question.As my poota room is so dusty is there any way of getting the front panel off to clean the rad without taking the side panels off?Thanks for any inf.

Smiffy

 

[stocky]

Pull from the top - there is just two push clips, one either side

That is on the standard black plastic cases anyway!

 

[maverik-sg1]

Pull from the top - there is just two push clips, one either side

That is on the standard black plastic cases anyway!

He's right it just pulls away.

Also - pump 1.85v into that CPU and see if you can push for 3ghz

 

[ZaX]

Be careful how you pull it, I broke mine the first day I got it which gave me a good excuse to get the Lian Li panel kit

 

[Smiffy]

Thanks for the inf guys.Got it off

I think on air i seem to remember she topped out at 2650Mhz on 1.85v.As on Prommie can give her a bit more.Just looking for a modded bios to see if I can push the fsb up a bit as haven't modded board for higher than 12.5 multipliers.Board is Epox 8RDA3G.Thanks all for inf.

Smiffy

 

[jellybeard999]

1.85v ... pfff

i ran my 2500 xp-m at 2.2v 24/7 on water at 2.8ghz back in the day

 

[Smiffy]

At last all running

XP2500 at the mo at 2950MHz on 2.025v(236MHz FSB X 12.5)

Running ok with no troubles so next a move to DFI SLI-DR with either 2 X 146 Opterons to choose from or 2 X 165 Opterons.

Smiffy