Lets be first here too...

ZaX

New member
Hi,

This is how my system use to look like before the Mach II upgrade, water cooled. I didn't like Asetek's pushfit fittings :mad: so I changed them all for proper plumbing stuff with jubilee clips :D that put an end to those dangerous leaks.

waterchill.jpg
 
closeup.jpg


This is an old pic of the bottom half of my present rig... 2 water loops inside... one for the CPU (A64) and one for the GPU (9800XT)... this is all dangerden with the chunky tubing...
 
Which case ?

Hi,

Thats mad stuff TC Overclocker ! Which case are you using there ?

Thanks,

ZaX.
 
current main rig & temps (gotta love that cascade block). Going phase change for the next one (AMD 64).. New cases have arrived & will be modded a little bit ;) then waiting on new pinouts / mobo to come out...

temps.JPG


side.JPG
 
Here's a pic of one of my DD4 setups. It was a bit messy around the edges but temps were very good. If I recall, I was getting about 27 degrees idle and 35 degrees under load, and that was a 3.2 P4 800FSB chip.

water.jpg
 
Back
Top