In need of a little bit of help

cbiltsouris

New member
hey everyone

I purchased 3/8 ID and 1/2 OD enzotech nickel plated compression fittings for my build, however I also purchased 3/8 and 1/2 primochill tubing and for some reason they dont fit!

unless im putting them on the wrong way or somthing?
 
Normally it would be 1/2 inch id tubing for 1/2 od fittings

if you're using compression fittings it will have to be the right tubing
 
for the 1/2 od compression fitting you should have 1/2 id 3/4 od tubing

If your tubing don't fit, there's something wrong somewhere
 
If the tube is 3/8"ID and 1/2" OD... And the compression fittings are 3/8" ID and 1/2" OD it should work, can you not get the compression ring over the tube?
 
can you measure the outside diameter of the tube. maybe they sent you the wrong stuff. Measure the compression ring as well. not the barb, but the removable ring.
 
Back
Top