Wiring the control board to the compressor (mains cables)

[K404]

This is my own fault, but after stripping down the Mach for cleaning, i`m now trying to put it back together for a couple runs, but I`m a bit stuck with the cabling to the compressor.

I made notes that say the neutral cable connects to a vertical spade-type pin on the back of the compressor. I`ve found this spade pin (theres a "12" underneath it) but theres a copper wire connected to it and the paddle grip on the neutral wire wont fit over it. Am I trying to put it in the wrong place?

Sorry for being so crap..I thought the notes I was taking were good enough, obviously they weren`t.

Kenny

Can get a pic up if you need it

 

[Thickbrit]

Here ya go,i hope you didn't break anything during disassembly.

 

[Thickbrit]

Oops,cocked up,will try again

Ah,here's what you need.....

 

[K404]

Oh...>Thankyou!

I`m also hoping I didnt break anything, but apart from a couple marks on the insulation at a corner, everythings looking good. i`ve patched that so that definately wont be an issue.

Now that i`ve got that info, I`ll be trying to Mach tonight (but not on my CPU)

*crosses fingers, though I dont think I need to*

Thanks Thick!!!!

Kenny

P.S... Saw the pic, dont worry!