Mullet's RIG

[imported_Mullet]

See pics below..

Moving over to water very soon tho..

What dya think?

 

[sacha35]

Nice and neat M8 thats what i like to see, leads to better airflow and temps, outside could do with a bit of MR sheen on though to take out all the finger prints, but outher than that very nice.

sacha

 

[imported_Mullet]

Thanks Sacha35.....

Like I say...it's all gonna change...MP05LE-SP on the way from Phil, already have the GFX waterblocks and chipset blocks...silence is my main reason....and obv. lower temps...gonna mod the case top to fit a PA120.2.....gonna be hard going but should be fun.....

Fingers crossed!!

 

[lamboman]

Nice wiring! Did you route it into the drive bay?

 

[Mindless-Moron]

Thats a really nice job mate, modding the top to accomodate a rad shouldnt be as hard as other cases as the top panel of the eclipse comes off doesn't it?

 

[boardy]

You can remove the Lian-Li top panels aswell by drilling out the rivets Can be done with most alu cases I think just incase anyone didn't know that.

It's a very neat and tidy job, I like that. I'd use 3/8" water cooling if I were you as 1/2" is gonna be HUGE in that case, and you'll struggle to keep it looking nice.

Very nice.

Boardy

 

[imported_Mullet]

Using 7/16th tube for the water loop.

Ta for the feedback all....

Just got my thermochill fan grill back from Phil...

Used to be polished silver....now looks like this (and matches my akasa eclipse 62).

Powder coating PWNS!:B

Will be removing case top tomorrow....and dremel will be doing the dirty work!!

Watch this space

 

[Phil Stanbridge]

Told you it looked good Daz!

 

[maverik-sg1]

Kudos my friend - very tidy job, for the record again I wish I had half the talent of the 'tidy' guys - mine all look FCUK'D but go like stink

 

[Master_G]

Fan grill looks very nice, good luck with the dremel work.

G