Chiller's Hybrid Level 10

[croimans]

SR-X will be for next build

 

[croimans]

some pics of extra PhysX vga that arrived,

some adjustment on fan, fan did make noise above 80%, fixed

New cooling paste on GPU = Evga Frostbite, fixed

New thermal pads better conductivity, fixed

Cleaned out, fixed

 

[croimans]

 

[wassupdoc]

Umm, where will the phys-x card fit?

Looks Great

 

[wassupdoc]

Ah just noticed- Ooooooh those power connectors look great now with the black cover, really finishes them off XD

 

[croimans]

the lowest gtx580 Classy can go 1 slot higher and then the thirth vga can go under it.

If needed i can put quad sli gtx580 in this case without no problem.

 

[croimans]

place enough, lowest gtx580 Classy just go 1 slot higher, because i kept a slot open for the fan of top vga.

I can even put 4 gtx580 in this case without no problem.

 

[wassupdoc]

Ah, are you going to use a new sli bridge then?

 

[croimans]

make one custom on black pcb

 

[dipzy]

 

[wotevajjjj]

I'm so loving this build.

You should get that power system patented really

 

[wassupdoc]

Can you do a picture from the rear, of the I/O and such?

 

[croimans]

rear? the only thing to see there is the EVbot connector that's routed to the front under dvd drive.

 

[MaXiMiZe]

Insane build

 

[wassupdoc]

Yeah, I'd just like to see how you've done the pcie power and stuff on the back

 

[croimans]

pciE extensions, nothing more.

 

[wassupdoc]

Pleeeeeeease? lol i just want to see how you've routed the cables

 

[croimans]

some small adjustments in rig,

so really everything is how i whant it :

this res comes in place of the top Coolit pump,

and the one under it will be changed by a koolance PMP-400 :

Bitspower Z-Multi 40mm Water Tank - Ice Red

also will ad a fan red led in bottom plate for some extra air for vga's.

ad some small red smoke acryl plates for finishing overal look when case is open to hide cables.

And then it's really finished like i whant it !

 

[croimans]

Removed the two Coolit pumps and replaced them with :

Swiftech MCP355

Aquacomputer top

koolance heatsink

Bitspower Z-multi red 40mm res

Temps are little lower now, higher flow.

Just need to make a nice mounting for the pump res combo (strapped for now) ,

make a fan in the bottom and finishing some stuff of cables and red acyl.

 

[frufsa]

I'm really not a big fan of this type of look, but this looks jus inzanly awsome, good work! will be watching this