Chiller's Hybrid Level 10

little update :

30arh5l.jpg


b8sidv.jpg


2ldd2ts.jpg
 
Your room must be bloody freezing, mate
laugh.gif
I say whack on Prime/Folding and leave it on for 24 hours to properly test the cooling kit.
 
here are the load temps, cpu temp in Coolit software is not correct, cpu isn't supported by the coolit software.

As you see idle the coolers run lower power, when stressed the coolers will raise there cooling power, and keep the liquid temp low, under Ambient,

cpu temp raises a 5 a 6°C from idle to load thanks to temp controlled coolers.

Temp of liquid is set @ 22°C max, min power of coolers @ 60%, max power @ 100%, real nice settings on these coolers,

and the coolers don't even run at 100% to keep the temp, for me that's good for lower noise level :

2lm5l50.jpg
 
little sneakpeak what i'm doing now :

Most of the time, people put there powercable for vga like the RED arrows.

I whant it as clean as possible in this case, en i will do my powercables like the GREEN arrow, straight horizontal with the vga's.

Vga's seems like they are floating in the air lol, strange sight.

On later time i can mod also the plastic cap on the vga, make it wider, little bit bigger, so the powercables are IN the plastic cap of the vga cooler, totally NOT visible.

30981f6.jpg


And this is the beginning of this little vga mod :

34fjt04.jpg
 
Am working now on the last mem flames, did the cables in the backpanel better now, so the back-panel is not round anymore,

and made some led's for give light to the mem modules :

2i0pwkn.jpg


snl4ig.jpg


3136t7l.jpg


2qxpz88.jpg
 
Killer2100 eifinally in the house,

original cover removed for modding it,

and here a pic of the killer2100 in operation with two red led's, what fits very good in the theme :

5pemtt.jpg
 
Next up is an Asus Xonar Xense or Creative X-Fi Titanium next?

There really isn't much else you can add to this now until you're constantly upgrading what you've already got.

Still
yumyum.gif
.
 
Back
Top