Phobya SLI VID Internal Diameter?

[grandpatzer]

Anyone measured or can make a guess on the ID on the metal tubing (thin part).
Not sure what to make of it, looks like it's just 5-6mm ID, even in paralell gpu's looks lite not good for a system with 19/13mm tubing?

 

[B NEGATIVE]

Its around 8mm ID.

Tubing does very little to flow,but 8mm is a touch tight.
Look at BP D-Plugs for Sli bridging.

 

[grandpatzer]

Its around 8mm ID.

Tubing does very little to flow,but 8mm is a touch tight.
Look at BP D-Plugs for Sli bridging.

You have measured it at the thinnest part(tubing edges)?

But having paralell I get the double flow?

the area of a circle is r*r*pi, so thats 4*4*pi=16pi.
2 sli connectors thats 32pi area.

Now I have measured fitting 13mm these have 10mm ID on thread, so thats= 5*5*pi = 25pi.

So in paralell I get more flow compared to 13mm fittings correct?

 

[B NEGATIVE]

tubing size doesnt matter,it all shrinks down to a 9mm bore for the fitting,this is why fat tubes do nothing. the 9mm bore of the fitting determines flow in and out of the block/rad.

 

[grandpatzer]

tubing size doesnt matter,it all shrinks down to a 9mm bore for the fitting,this is why fat tubes do nothing. the 9mm bore of the fitting determines flow in and out of the block/rad.

Are you entirely sure the Phobya SLI is 8mm ID?

I currently have barbed sli fitting with 8mm ID.
Having paralell with Phobya Sli gives me double flow.

Then my lowest flow in tubing would be 19/13 compression fitting (bore ID is 9.8mm)