maniac
New member
So, i had this piece of plexi laying around and as i always wanted to do something with the top and the front of the switch 810, i decided i'll do another front and top ( not to ruin the original ones) and in the same time learn some stuff 
still wondering about a good way to stick them together as i dont want it to be permanent and i dont want to drill the plexi. any suggestions would be really appreciated.
i still need to buy the mesh and as soon as the front will be done, i will start working on the top part. that will be more of a challenge to mount but we'll see along the way
Build Specs:
Case : NZXT Switch 810
Cpu : Intel Core i7 950
Motherboard : Asus P6T
RAM : G.Skill Pi Series 6GB 1600Mhz
Graphics : Nvidia Geforce GTX580
Cooling : Corsair H50
PSU : Corsair HX850
Hard Disk : Intel 520 120GB
Regards
Maniac





still wondering about a good way to stick them together as i dont want it to be permanent and i dont want to drill the plexi. any suggestions would be really appreciated.
i still need to buy the mesh and as soon as the front will be done, i will start working on the top part. that will be more of a challenge to mount but we'll see along the way

Build Specs:
Case : NZXT Switch 810
Cpu : Intel Core i7 950
Motherboard : Asus P6T
RAM : G.Skill Pi Series 6GB 1600Mhz
Graphics : Nvidia Geforce GTX580
Cooling : Corsair H50
PSU : Corsair HX850
Hard Disk : Intel 520 120GB
Regards
Maniac
Last edited by a moderator: