Moniter Temps and Fan Control

[Goggle Eye]

Case Mountain Mods Front Panel 9 120 blow holes. Rear Panel 4 120 Blow Holes.

2-360 rads front panel, 2-Uber pumps, 2-250 Reseivors.

Loop One: In this order, Full M/Board Block, CPU, Volt Reg.

Loop two: 2 Nvidia GTX 580 FW Hydro Graphic Cards.

Coolant distilled water, two 9.99 silver coils.

Will this keep out the algie if I change the water every three to four months?

No water Additives. I want to keep my water blocks and pumps clean from die build up.

Do I need to moniter the water temps?

I Want to moniter the temps on CPU, M/Board, 2 Graphic Cards, 4 Velocity Rapter hard drives.

Want to moniter and adjust the 9 front fans on 2-360 Rads, 2-120 fans 2 H/drive racks (2-H/drives per rack)and one 120 mm fan.

What is the best way to controll the front 9 fans and moniter temps? 2-5.25 bays available for use.

I was going to run the 4 rear fans from the M/Board & controll them thru B.I.O.S.

Thanks for all the help.

 

[ShortAlieN]

that is one massive build for your first. good luck. I kept it small for mine

 

[Goggle Eye]

that is one massive build for your first. good luck. I kept it small for mine

 

[Goggle Eye]

I decided to build one wiring harnes for 2 rads 6 fans.

Chanel one = Loop one. 3 fans with one temp probe on the CPU Block.

Channel two = Loop 2. 3 fans with one temp probe on the bottom 580 GPU.

Channel three: 2 fans with one temp probe on the 4 Velosity Rapters Raid 0 + 1.

Channel four: One fan above the Velosity rapters with one temp probe to moniter the temp in the front top of the case.

I am using a Lamptron 4 channel fan controller temp read out. 45 w unit.

Will this be enough watts for the fans with out damaging the unit or burning up the fans?