Mach II GT "Shudders" when computer powered off

[K404]

I hooked up my Mach tonight for the first time, and everything went well. However, when I powered off the computer, the Mach kept trying to trigger, and the shudders it gave off were kinda disconcerting. The Power and reset cables to the Control Board werent connected, but the USB and molex were. What was happening, and why? When it gets connected properly to the mobos power cable etc, will this stop? I tried shorting the Control boards power and reset cables, but it didnt do anything

Thanks for the help (always grateful)

Kenny

 

[fatty]

Firstly hook the unit up properly then flash the firmware would be my suggestion and all your problems will go away

 

[K404]

Cheers!!

Kenny

 

[fatty]

No probs I still want a copy of that benchmark proggy too mate I treid to buy it but the next issue is out loool

 

[K404]

nae bother... PM me your address and it shall be done with your clock speeds i`m expecting something on par with Mr Gollums score