Loop Order and Jump Starting The PSU

[Ollii]

Hey, firstly I am wondering about my loop order. Now I am well aware that tom always says any order, just make it look clean. However does this literally mean I can connect everything up without worrying about which bit of tubing goes from the inlet of one component to the outlet of another etc? (Hope that made sense

)

Secondly, for jump starting the PSU do I need to have all the components connected up all ready, so the motherboard 8 pin and all the sata's for the hard drives etc? or just the pump? or maybe something else?, I'm really not sure.

Please could I have some advice on these matters, many thanks

 

[tinytomlogan]

Its only really the CPU block that will have a direction, and only some of them at that. if you have a seperate res / pump then you should do res -> pump but other than that it doesnt really matter.

You can always post photos of the rig with the blocks BEFORE hosing and ask for some advise. Sometimes better to take your time and ask than rush it and ruin it.

When you jump the PSU you just have the pump powered nothing else. Although none of it will be on its best to play it safe incase you have leaks.

 

[Ollii]

Its only really the CPU block that will have a direction, and only some of them at that. if you have a seperate res / pump then you should do res -> pump but other than that it doesnt really matter.

You can always post photos of the rig with the blocks BEFORE hosing and ask for some advise. Sometimes better to take your time and ask than rush it and ruin it.

When you jump the PSU you just have the pump powered nothing else. Although none of it will be on its best to play it safe incase you have leaks.

Thanks a lot, I might post some pictures up soon then just to double check

 

[Ollii]

Removed Post