Just started Folding for Redline@OC3D

[VoraciousGorak]

well first of all i run my 2500k at 4.8GHz. also if you are using the "FAH GPU Tracker V2" (which i recommend you do) go to Setup-->Configure and there i have the following checked:

enable cpu folding

use multi-core smp client

use all cpu cores

add -advmethods

disable hiding clients

enable gpu folding

enable gpu0

gpu3 client

nvidia fermi

add -advmethods

(from top down on the left and the top down on the right)

try those setting and see what you get, if u don't see an improvement try OC-ing a little more, remember if you cooler can handle it most people agree that it is 24/7 safe to run ur cpu at 1.37V (personally i have it at 1.33 in bios because i found it was the best oc/heat)

I doubt the GPU settings have much to do on the CPU side, this PC has a 6950 anyway. I'll try the "Disable Hiding Clients" setting, but my 4.2GHz vs. your 4.8GHz should only be a 14-15% difference.

Maybe memory speed, I'm running mine at 1600 right now? I didn't think that had a lot to do with it.

 

[mrDMxtreme]

i have 8gb of memory running at 1866, but i didn't think that would really matter.

also the gpu kinda matters because when i fold i usually fold with both cpu+gpu so my cpu ppd goes down by a tiny bit

 

[kilobravo]

I had 7% increase,going from 1600mhz to 2133mhz rams.The i7-2600k loves ramspeed.