EK-CSQ Crossfire help

[Jacob.xray]

OK i was looking at the EK Full Cover VGA Block EK-FC7970 Acetal+Nickel CSQ and if you look at it there is only holes on one side so how do i do crossfire with these blocks.

Link: http://www.pccasegear.com/index.php?main_page=product_info&products_id=20861

so i was looking around and i found EK-FC Bridge TRIPLE Serial CSQ but couldn't find the link for the new CSQ design anywhere.

LINK: http://www.performance-pcs.com/cata...info&cPath=59_971_1018_1038&products_id=34579

 

[Mummy]

Hi,

OK i was looking at the EK Full Cover VGA Block EK-FC7970 Acetal+Nickel CSQ and if you look at it there is only holes on one side so how do i do crossfire with these blocks.

With older non CSQ -model you get holes on both side of the block, so you gan use tube betwean them, but now with new line you haveto buy that block betwean them.
Edit: oops not true, read the installation manual. http://www.ekwb.com/shop/EK-IM/EK-IM-3831109856697.pdf

so i was looking around and i found EK-FC Bridge TRIPLE Serial CSQ but couldn't find the link for the new CSQ design anywhere.

What you mean? There isnt old CSQ is there?

I would stay out of nickel plateing, but its every ones own choice.
Heres a nice look of EK's nickel, after little time. http://forum.overclock3d.net/showthread.php?t=44958

 

[Timeless]

The small block on the card (EK-FC link) is included with the water block and then you need to buy the right size EK-FC bridge for your setup to link the different cards together.

And there is only non-CSQ (old) and CSQ (new), nothing else.

 

[Jacob.xray]

The small block on the card (EK-FC link) is included with the water block and then you need to buy the right size EK-FC bridge for your setup to link the different cards together.

And there is only non-CSQ (old) and CSQ (new), nothing else.

ok that would explain why i couldnt find it for dale if it is included with the block

 

[Thundercg]

Is that bridge serial or parallel? I'm using that bridge for my 680s

 

[Jacob.xray]

Is that bridge serial or parallel? I'm using that bridge for my 680s

Parallel for 3 way xfrire