Copperhead Lian Li X79 Copper Pipe

[alpenwasser]

I'm thinking that the picture MAY be mirrored? The little RGB box says it require 12VDC 6A. Thank-you very much for that link though
Here is a picture of the IR receiver with the 12V power supply plugged into it.

Hm, yeah maybe that's it.

12 VDC 6A? That's 72 W! Holy hell that thing is hungry! :lol:

Anyway, two possibilities I can think of at the moment: Figure out which of those two
wires carries the 12 V and which is ground, cut the cable and mod it into a Molex
plug, or maybe ask bsmods how they did it, maybe they would give you the info?

 

[garih]

With that type of connector the centre of the plug is normally the plus/+/positive. So I would cut the terminal off the adaptor test which of the wires is connected to the centrepin cconnect that wire to the +12v on the molex. Connect the other wire to the ground. That should be correct.

 

[reeper250]

Sorry I have been inactive on this build. I just wanted to setup my system so I just used a Phantom (http://forum.overclock3d.net/showthread.php?t=55232).

Also, I really wanted to get the MSI Big Bang XPower II motherboard but it is XL-ATX and so it won't fit inside the V2010 case. Anyone have some ideas? I was thinking of possibly moving the PSU from the rear to the front then making a new midplate with the rear of it being lowered enough to fit the extra part of the motherboard.

I have cut up the 12V PSU getting ready to attach a molex to it. Been pretty busy lately because I only have a few months left of my final year in high-school which is taking priority. I will finish this though

EDIT: Finally found some fans that may be used for the radiator: Alpenföhn 140mm Wing Boost PWM
They are PWM fans which are quite handy, low noise, decent static pressure, rubberised material (therefore reduced vibrations), orange (almost copper looking) inner ring, also I can get them for $12 each from The Kool Room: http://www.thekoolroom.com/product/alpenfohn-140mm-wing-boost-pwm/

 

[reeper250]

Had to put this on hold for a while due to currently not having a job, therefore, limited funds so I sold the hardware for this build although I still have the case, etc.

 

[garih]

Sorry to hear that, good luck finding something.