3dmark 11 - red dots in screen in performance 1 test.

I will try. But before i want to ask. If fraps dont capture that dots its a monitor cable fault? Or this doesnt matter?

Could be your monitor or its cable. Run the iGPU first as Dice suggested with the same monitor and cable. If it still happens you will know that it's not your GPU.

Then you can look if it's maybe the cable by replacing it, or your monitor by trying a different one. Or maybe even dodgy software (is your copy of 3D Mark legit? Have you tried re-installing it?).
 
i must change in bios something to use intergrated gpu or not?

As Feronix said just take out your GPU and plug your monitor cable into the motherboard, There should be a port on the back.

If it boots and the screen is ok then sorry to say but it will most likely be a faulty GPU :(
 
ive seen this error before...

answer is its the video cable.
last time i saw this was on a 23 inch samsung monitor the dvi cable had 2 bent pins which caused the issue.
i would swap to a hdmi cable or different dvi dependent on which you have :D
 
ive seen this error before...

answer is its the video cable.
last time i saw this was on a 23 inch samsung monitor the dvi cable had 2 bent pins which caused the issue.
i would swap to a hdmi cable or different dvi dependent on which you have :D
Oh god I remember that! It was a signal interruption caused by the pins.
 
Problem solved. New cable and no dots

I have a question last. So if yesterday i was toying with my old cable ( plugging and unplugging DVI display when pc was on game was on )its not harmful to GPU?
 
Back
Top