Wantec: someone with technical drawing or CAD expertise

[FarFarAway]

My project is a little stuck at the mo (and now I actually have some time to get on with it), as I need to do some drawing for a lazer cut but frankly I suck and don't want to get it wrong.

If anyone can help with some drawings (on the PC) to get to a lazer-cutter and cut my side panels I'll love you long time

 

[Barry]

So what, orthographic drawings?

If you give me some details, I'd more than happy.

 

[FarFarAway]

I'm on MSN if you're free mate

 

[Barry]

Sorry, boarding school, and a horrible loathing of technology.

I could give you an e-mail that I seem to allways be using?

 

[FarFarAway]

OK - the case I have is a A+ Case Black Pearl (same dimensions as a Lian Li PC5000 iirc). I need to fit two 240MM black Ice rads in the bottom but need a hole each side for fans to breathe when they are attached to the RAD

That good to start?

EDIT: Thread here

 

[Barry]

So you want a 1:1 drawing of the mounting holes or something?

 

[Hassan]

Sorry to be of no use, but can somebody here tell me where u can get laser cut for cheap.

 

[FarFarAway]

So you want a 1:1 drawing of the mounting holes or something?

Well it's the drawing of the holes for the rad grill

 

[Kerotan]

You wouldn't mind telling me what CAD software you used to model those up would you? I tell you what Kempez those aren't half bad! I use ancient PRODesktop for my CAD [it was free lol] but that's some great skills you've got there, can you not just put the holes where you want them in the 3D view then convert that to a cutting plane or section plan on a drawing to send to the place?

 

[FarFarAway]

Those are from Sketchup but I just took a pre-made model of a Lian Li and changed it

 

[Kerotan]

Ah right, cheers I'll have to check it out sometime, good luck with the rest of the project anyway.

 

[Barry]

Kemp, I'm off to do some CAD this afternoon to give you and idea of what I can do.

 

[Seanrb]

A 2D setting out drawing that can be overlayed on the panel to cut the relevant holes?

I can do you one in AutoCAD in a couple of minutes if you have got the dims.

My job is CAD, setting out drawings for buildings amongst other things.

MSN me on orange__hitman (AT) hotmail.com (2 underscores) tomorrow morning at about 10:30 (UK time) if you want me to do it.

 

[FarFarAway]

Bugger soz aint been around and am going on hols soon

Add me and MSN me i I'm around

 

[Seanrb]

Will do tonight

 

[Seanrb]

I can't get onto your profile to get your MSN address...

 

[FarFarAway]

kempez815 (at) hotmail (dot) com

 

[Marcus]

Did you get this sorted Matt or has it gone on the back burner for a while?

 

[FarFarAway]

No was on hols mate

Am back now but didn't get to BnQ

Needs to get on the front burner, am fed up of parts sitting around

 

[Marcus]

No problemo, you know where to find me!