The Phoenix's Rig TJ07 Waterccoled

[thephoenix]

Hi guys my first post been watching for some time and keep meaning to post pics of my rig.

so here goes.

let me know what you think dont be too harsh

 

[Ham]

Looking good mate. I think you could do with stealthing the fan in the drive bays (if its not already and just been taken off for the pic), but other than that nice job!

And welcome to the forums.:wavey:

 

[lamboman]

Looks pretty good, but I would clean those cables a bit more. Otherwise, it is nice

 

[PV5150]

Nice one mate and I love the case - we're brothers rofl. Cabling needs a bit of a tidy up and is that the HDD caddy from a CoolerMaster Stacker 830?. I tried that myself and found that it elevated temps considerably. Welcome to the forum too mate

 

[thephoenix]

Yeah cable management is a priority on my list.

problem is the PSU is a Tagan so the cables are really thick and have a plastic anti interference block thing on them which gets in the way.

and yes mate it is a hard drive chassis thing from a stacker, not found temps too bad really even the raptors.

yeah i got the black bezel things to cover the fan but i get a little worried about restricting the air flow for the fan, really its only temporary until i get the proper silverstone one.

cheers for you comments anyway.

 

[PV5150]

yes mate it is a hard drive chassis thing from a stacker, not found temps too bad really even the raptors.

Have you seen the Silverstone HDD caddy that they make?

 

[rrjwilson]

I have two of them things one in server one in my behemoth and they work for storage but temps are high is all air cooled. Now im WC its fine.

Nice tidy (apart from cables) case well done looks good.

Check my thread for further diabolical cabling

 

[khemist]

Nice, will be going for one of these for my next case or a cosmos s.

 

[Socks]

Love it!!!!!!

 

[GavX]

looking good, I want one of these cases myself, but daaaamn they cost an arm and a leg looking great, can we get a few more pics frrom differen angles?

 

[k4p84]

Rad does seem to be unsecured down there

 

[doug2507]

Is the rad flat? Looks like the fwd edge is sitting on the curve of the case. You can see the screws on the fwd fan and not the rear. Might just be the phot? Otherwise, looking good!

 

[zzhang]

You could always get a SCYTHE "KAMA BAY" seems like it should suit your case.

 

[doug2507]

Got one surplus to requirements if you want it. Also a CMD01 ESA module....

 

[Brooksie]

Where have / are you going to place your SSD?

 

[Ghosthud1]

yeah the rad seams to be on a slight wonk (a tad drunk) but yeah stunnning build im gunna do a project like this soon

 

[EverydayDiesel]

nice setup for sure

 

[Curtis]

Really impresive rig, Bet temps are really low in there

 

[jeffel]

Nicely done