The G.E.C.K.
- Thread starter AlienALX
- Start date
AlienALX
Well-known member
Sadly we had a problem. When I took the blue piece and laid it over the yellow this happened..
I am flummoxed. In the end I took the piece I drew up, re-traced it, put it back in Easel and...
Yeah, god only knows.
OK, trying that again lol
Bit snapped. Ugh.
Thankfully I came up with a new idea. Bottom left on the piece you can see a small mark. I use the manual control to mark exactly where the bit started. In the past if a bit snapped the piece went in the bin. However, now that I have learned to mark it? I just changed it out to a 1.6mm bit and started the machine again.
I sat in for the first two goes around and yeah, it is absolutely bang on. So hopefully it will now stop being annoying.
I am flummoxed. In the end I took the piece I drew up, re-traced it, put it back in Easel and...
Yeah, god only knows.
OK, trying that again lol
Bit snapped. Ugh.
Thankfully I came up with a new idea. Bottom left on the piece you can see a small mark. I use the manual control to mark exactly where the bit started. In the past if a bit snapped the piece went in the bin. However, now that I have learned to mark it? I just changed it out to a 1.6mm bit and started the machine again.
I sat in for the first two goes around and yeah, it is absolutely bang on. So hopefully it will now stop being annoying.
