radiator fans and controller thought

[SparkleDJackson]

hello on my future build i was planning on including a fan controller (scythe kaze master pro or nzxt sentry lx) and i as wondering i would like to control both sets of fans (dual loop 6*120mm per rad) as united entities so on the first set of rad fans set to control 1 and fans on rad 2 to control 2 leaving the other 3-4 points open for use in other areas of the system. i covered electrical engineering like 4 years ago it my class and after i left i went straight into working in a bearings shop so the knowledge was not needed and therefore over the course of time powdered off to the park with its mates for a bottle of lucozade. so im thinking the power draw also maybe pe a factor so if there some sort of device that could be used to give the fan clusters all the juice they need but also combine the signal into one for the controller. i know the controller is not nescessary but i just think it would be pretty cool seeing the little display saying good job darin -15oC @ 15000rpm (exageration im not thick). any help you dudes can give would be uber appreciated i know this is about fans in the wc section but because its in relation to rads i thought maybe a few wc vets would have thought of this well before me. cheers

 

[tinytomlogan]

I understand all the words, but as a paragraph I have no idea what you are trying to work out.

 

[SparkleDJackson]

haha dude. so a fan controllers outputs i want to know if it is possible to have a 6 fan equipped radiator wired to the controller as tho it were only 1 fan so i dial in the speed on the front of the unit and then all fans that are linked will run in unison in regards to the speed level set by the controller. i dont know if that helps decipher the occasional lunacy that come from my thinking box

i suppose i really should learn to use enter and tab more often

 

[ciksas]

P=UI

The scythe kaze master pro supposedly handles 12W per channel, nzxt sentry 4W per channel.

 

[tinytomlogan]

So 6 fans on one dial? The fan cont wont output enough to make them spin anwhere near max, pairs is about as far as you can go and even then you wont get the same speed as you would if the fan was wired to a molex on the PSU.

 

[SparkleDJackson]

Rightyeo so forget the idea then lol as it aint possible. Excuse me while i go out into the night to scream obsenities into the rain. The i will return inside and click the post button and continue have a dinnerless night. Peace out dudes cheers for your thoughts

Darin out

 

[Ghtt-tourer]

get the rheobus (something, something, i think its called) 30w per channel

or the lamptron or lampton (again something like that) has lots of amps....