FINAL AND READY FOR CLEANUP THEN SHIPPING!
The units been changed to face with even higher loads on my new tester now 270-300 at -35C or colder. An SLHX and my custom subcooling enhancer has been installed, as well as a solid state relay fan controller. This unit keeps the same -35 to -38C across 100 to 300 watts
.
On to pics, just need to clean it up and cut a new board.
----------------------------------------------------------------
This units for Harvshark, a member of XS. He recently had his Vapo LS get abused, raped, then plundered by a QX6700's heat load, he turned to me to build him a monster. So, a 1/2hp Danfoss SC12MLX, a large modded condenser with large axial fan, and a 36" braided flex line with a Runmc evaporator on the end.
Screw the details, here's some pics!
The units been changed to face with even higher loads on my new tester now 270-300 at -35C or colder. An SLHX and my custom subcooling enhancer has been installed, as well as a solid state relay fan controller. This unit keeps the same -35 to -38C across 100 to 300 watts

On to pics, just need to clean it up and cut a new board.



----------------------------------------------------------------
This units for Harvshark, a member of XS. He recently had his Vapo LS get abused, raped, then plundered by a QX6700's heat load, he turned to me to build him a monster. So, a 1/2hp Danfoss SC12MLX, a large modded condenser with large axial fan, and a 36" braided flex line with a Runmc evaporator on the end.
Screw the details, here's some pics!








