Surfie
New member
I would here by like to hold a minute of silence for my Silverstone power supply. After about 5 years of use it has gone to the great computer heaven.
*plays the last post*
So, here is what happened. I was pulling apart the old loop to make some adjustments, when I spilled a little water into it. A accidental of course. So I leave it a few hours, passing the time by setting up the new blocks and figuring out the new loop order etc. After about 4 hours, I think "hmmn, I didn't spill much water into the psu, it should be dry by now.", and so, give it a dry test run (heh pun), by which I mean nothing connected to it, just power it up. I'm glad nothing was plugged in though. There was a loud bang and then smoke poured out of the psu.
Now I need a replacement. Any suggestions?
*plays the last post*
So, here is what happened. I was pulling apart the old loop to make some adjustments, when I spilled a little water into it. A accidental of course. So I leave it a few hours, passing the time by setting up the new blocks and figuring out the new loop order etc. After about 4 hours, I think "hmmn, I didn't spill much water into the psu, it should be dry by now.", and so, give it a dry test run (heh pun), by which I mean nothing connected to it, just power it up. I'm glad nothing was plugged in though. There was a loud bang and then smoke poured out of the psu.
Now I need a replacement. Any suggestions?