Is this a good idea?

[Mercer95]

So I’m thinking of chopping up my CM storm enforcer case so that I can fit a 200mm radiator and another 200mm fan at the front of my case and then I was thinking about putting a double 5" drive bay reservoir above it and so on, it will involve removing the hard drive bays and maybe removing one of the 5" bays, then i can move the hard drive cage towards the PSU and once that is done I am thinking about putting a false floor in covered in carbon fibre vinyl sheet.

Do you guys think that it will be a good idea or not?

Also what are the best tools for the job? i was thinking a dremel but i can get hold of most tools no problem.

This will be my first case mod but it shouldn’t be a problem because it’s a fairly simple case mod and I’m pretty good with my hands.

**im not sure if this is the right place to post, please correct me if it isnt**

 

[dalewakelin]

Project logs probably.
Awesome idea, i like!

 

[reeper250]

Just make sure there is enough clearance for the radiators and you should be fine.

 

[CPMFW]

sounds really promising...

 

[reeper250]

Inspiration:
Source
http://www.overclock.net/t/1038918/the-cooler-master-storm-enforcer-club/520
http://hardforum.com/showthread.php?t=760053&page=50

 

[Ralm]

Wow that white tubbing is awesome. And what CPU block in that with blue light? in the case with the white tubing?

 

[CPMFW]

xspc raystorm

 

[reeper250]

I personally use one in my main system. It comes with blue LED's but they can easily be swapped out for other colours.

Scroll to the bottom of the page (my build log):
http://forum.overclock3d.net/showthread.php?t=39485&page=15

 

[whosbawss]

personally I would stay away from bay res and pumps and get a tube res instead as with a bay res you have to have more tubing to allow for filling and air bubbles drain quicker in a tube res and.... they look a lot better in a case =D in my opinion.