Is the following score decent for my POS machine (3dmark)

loserp3

Member
2i6gi.jpg


thanks for your reply, guys.
 
Hmm. Did you change the factory settings? You Physics (or CPU) score looks really high and your Graphics score looks terrible.



670 SLI on a CPU the same as a I5 2400.
 
It's still semi comparable as you know that your result should be quite a bit higher than mine. The site allows you to compare with similar hardware results anyhow.
 
Was that mark obtained from running the Firestrike in Extreme mode ?

No, just the normal mode. Did you run yours in Extreme?

Always run these sorts of tests "as they come" at first dude, it makes it a lot easier to compare them. Hardly any one uses the extreme modes so it's harder to find results.
 
I have the same hardware - same CPU, GPU and board at least if you want me to run things. My RAM's considerably slower though so that may influence things.

What exact settings did you use on 3d mark?
 
I have the same hardware - same CPU, GPU and board at least if you want me to run things. My RAM's considerably slower though so that may influence things.

What exact settings did you use on 3d mark?

I can attest that ram speed makes no difference mate :)

I ran it at 1866, 2000 1333 and 1600 and no change. This was when I could clock up my Radioactive without having Blackline in there.
 
I've a score of 6745 running the stock fire strike test, is it ok ?
Do you have your GTX 670 OC'd ?

thanks for your help
 
I have two GTX 670s dude. Neither are overclocked and both were held back by my CPU..

It's the graphics score you want to look at. If yours is over half of mine then you're spot on :)
 
I'm guessing you were talking to me when you asked if the GPU was overclocked? Yes it is, boost clock is 1185mhz, memory clock is 1715mhz.

I'll run Heaven - having to download 4.0 - was on 3.0 before so give me a few minutes.

Edit:

hvdzDEp.png
 
Last edited:
Back
Top