INTEL P4 3.2 Ghz EE

[M8tRiX]

Hi All,

Right i have been running this rig for a week at stock speeds and need help overclocking it.

Was a AMD & ATI boy before, bah tiz history now

I just need help with overclocking my setup, i have the following:

P4 3.2 Ghz EE

1GB OCZ 4200 EL

OCZ DDR Booster

ASUS P4C800-E Deluxe BIOS: 1016

Mach 11 GT

Any help on FSB settings, voltage, memory timings etc would be great.

Thanks,

M8tRiX

 

[Dazboots]

put the ddr boosters @ 3.4 volts drop memory to 2-5-4-4-5

up front side bus to 256 @1.8 volts

mach 2 gt fans on full.

i know this cos i had the very same setup.

u might need to turn the cpu volts a bit more.

sometimes i put mine up to 1.85 volts.

the EE LOVE volts dont be scared.

look @ my sig it says it all m8....

 

[M8tRiX]

Intel 3.2 Ghz overclock

put the ddr boosters @ 3.4 volts drop memory to 2-5-4-4-5

up front side bus to 256 @1.8 volts

mach 2 gt fans on full.

i know this cos i had the very same setup.

u might need to turn the cpu volts a bit more.

sometimes i put mine up to 1.85 volts.

the EE LOVE volts dont be scared.

look @ my sig it says it all m8....

Dazboots,

Do i up the fsb 10mhz at a time whack it straight up ?

Th ddr booster do you turn it up when the system is running ?

How do i turn the MACH 11 fans on full ?

Also the memory i have it currently at 2.5-4-4-7 don't know what the other memory setting are. Could tell me what each number referes to, soz m8 bit of a noob at settings.

Just ran some benchmarks at stock speeds and got 22774 for 3DMark2001 and 13328 for 3DMArk2003 is that about for stock settings ?

Thanks,

M8tRiX

 

[Animal]

1. at a time..

2. u plug the booster in and boot into bios and calibrate it to read the same voltage as wat the mobo is putting out.. then u turn the nob to the desired voltage then exit bios and boot to windows...

3. Use the mach 2 Control center software that u installed..

4. Here is a memory guide..

 

[M8tRiX]

Overclocking Stuff

1. at a time..

2. u plug the booster in and boot into bios and calibrate it to read the same voltage as wat the mobo is putting out.. then u turn the nob to the desired voltage then exit bios and boot to windows...

3. Use the mach 2 Control center software that u installed..

4. Here is a memory guide..

Hi All,

1. Got that.

2. All calibrated

3. She now sounds like a tornado

4. Left the timing at 2.5-4-4-7 for now change this when the FSB settings are done.

Thanks,

M8tRiX