having a problem

R

RombieFitch

New member
I upgraded the cooling in my system to a water cooling system. After i was done installing my loop, i turned my system on and the motherboard poast Dr Debug code 36. I have an Asrock z77 extreme9 with a 3770k. I researched this code and it looks like my cpu wont post at all. I tried resetting my cpu, only put on memory stick in. hit CMOS clear switch and nothing. same problem. Is it possible my cpu is dead or did i screw up my motherboard? Any new suggestions that i can try?
 
Take out all the ram and place one module back... see if it posts. Do this for all the ram modules to figure out if one is faulty(do not forget to test all the dimms aswell). If there's still no result re-seat the CPU.. and test all the ram modules again as before.
This is what i would do at first glance, but hell maby you did kill the mobo with a screwdriver... it all comes down to trial and error...

Good luck!
 
GBcf said:
Take out all the ram and place one module back... see if it posts. Do this for all the ram modules to figure out if one is faulty(do not forget to test all the dimms aswell). If there's still no result re-seat the CPU.. and test all the ram modules again as before.
This is what i would do at first glance, but hell maby you did kill the mobo with a screwdriver... it all comes down to trial and error...

Good luck!
Click to expand...

I think when i put the waterblock on, i might have over tighten.. I tried what you suggested after doing research. I will try it again for sure. If i can't get it fixed, i'm waiting for haswell.
 
You must log in or register to reply here.

Similar threads

Zoot
100TB New(ish) Home Server Build
Replies
6
Views
3K
hmmblah
hmmblah
K
Haf an upgrade...
Replies
0
Views
1K
koryusai
K
R
Corsair iCue-Link 5000X upgrade
Replies
3
Views
7K
robert3892
R
K
Upgrade to AM5 from X79, water or air strait away?
Replies
2
Views
2K
Avet
Avet
TalllPaul
PC isn't booting up
Replies
8
Views
3K
TalllPaul
TalllPaul
Back
Top