Gromacs cannot be completed?

[AMDFTW]

hey ppl,so i was folding yesterday and i had both clints running (460,phenom 2) so i check back at 12pm and my cpu was saying 24% 'gromace con not be completed' so i dont no what the hell that is,it does it a few times as well,also its going alot slower now.

cheers

 

[stevehat1]

I think that message is usually related to stability issues.....

 

[AMDFTW]

but the CPU is stock mate

 

[stevehat1]

It could be caused by a number of things, Possibly a faulty work unit, but those are pretty rare. could be memory, heat issues on the cpu or mobo some where.

If happens frequently it is an issue, if it happens once just move on and forget about it.

 

[SnW]

I had this happen ones or twice and both times it happened when i was at stock speed,

looked it up and both client cores where faulty apparently so as Steve said delete any faulty work and carry on no worries yea well a shame if you Folded a large bit of the WU ...

 

[AMDFTW]

hmmm so i will delete the work folder and start again,just dont wanna lose any points.

yer each time is was 97% lol

 

[stevehat1]

hmmm so i will delete the work folder and start again,just dont wanna lose any points.

yer each time is was 97% lol

If it died at the same point 2 times it's a bad work unit and should be reported at Stanford. there is a section in the fourms to report bad work units.

 

[SnW]

If it died at the same point 2 times it's a bad work unit and should be reported at Stanford. there is a section in the fourms to report bad work units.

And again agreed with this man,

and for the lazy.. link to reporting issued WU´s thread at FaH Forums

http://foldingforum.org/viewforum.php?f=19