[font="Verdana, sans-serif, FreeSans"]I also posted this in the sticky thread too, was not sure where to post this.[/font]
[font="Verdana, sans-serif, FreeSans"]My first time overclocking. I tried to oc but I need some help with my oc on my 950. my goal so far is 3.8ghz. I dont want to oc the ram. i run prime95 cpuz and coretemp and my pc shuts down with the blue screen.
the temps were hitting 65-69c on coretemp. my set up is i7 950, sabertoothx58, g.skill 6 gig ddr3 1333, hyper 212+ single stock fan. HAF 932 case
I tried it with 1.66 and 1.5v and had same problem. i probibly made a noob mistake
[font="Verdana, Tahoma, Arial, Calibri, Geneva, sans-serif"]Ai Overclock Tuner - Manual
CPU Ratio Setting - 21
Intel ® SpeedStep ™ Tech - Enabled
Intel ® Turbo Mode Tech - Enabled
BCLK Frequency - 181
PCIE Fequency - 100
DRAM Frequency - DDR3 auto[/font]
[font="Verdana, Tahoma, Arial, Calibri, Geneva, sans-serif"]DRAM CAS# Latency - 8 DRAM Clock
DRAM RAS# to CAS# Delay - 8 DRAM Clock
DRAM RAS# PRE Time - 8 DRAM Clock
DRAM RAS# ACT Time - 24 DRAM Clock
CPU Voltage 1.20000v
CPU PLL Voltage - Auto
QPI/DRAM Voltage - Auto
IOH Voltage - Auto
IOH PCIE Voltage - Auto
ICH Voltage - Auto
ICH Voltage - Auto
DRAM Bus Voltage - 1.66v
DRAM DATA REF Voltage on CHA - Auto
DRAM CTRL REF Voltage on CHA - Auto
DRAM DATA REF Voltage on CHB - Auto
DRAM CTRL REF Voltage on CHB - Auto
DRAM DATA REF Voltage on CHC - Auto
DRAM CTRL REF Voltage on CHC - Auto
Load-Line Calibration - Enabled
CPU Differential Amplitude - Auto
CPU Clock Skew - Auto
CPU Spread Spectrum - Auto
IOH Clock Skew - Auto
PCIE Spread Spectrum - Auto[/font][/font]
[font="Verdana, sans-serif, FreeSans"]My first time overclocking. I tried to oc but I need some help with my oc on my 950. my goal so far is 3.8ghz. I dont want to oc the ram. i run prime95 cpuz and coretemp and my pc shuts down with the blue screen.
the temps were hitting 65-69c on coretemp. my set up is i7 950, sabertoothx58, g.skill 6 gig ddr3 1333, hyper 212+ single stock fan. HAF 932 case
I tried it with 1.66 and 1.5v and had same problem. i probibly made a noob mistake
[font="Verdana, Tahoma, Arial, Calibri, Geneva, sans-serif"]Ai Overclock Tuner - Manual
CPU Ratio Setting - 21
Intel ® SpeedStep ™ Tech - Enabled
Intel ® Turbo Mode Tech - Enabled
BCLK Frequency - 181
PCIE Fequency - 100
DRAM Frequency - DDR3 auto[/font]
[font="Verdana, Tahoma, Arial, Calibri, Geneva, sans-serif"]DRAM CAS# Latency - 8 DRAM Clock
DRAM RAS# to CAS# Delay - 8 DRAM Clock
DRAM RAS# PRE Time - 8 DRAM Clock
DRAM RAS# ACT Time - 24 DRAM Clock
CPU Voltage 1.20000v
CPU PLL Voltage - Auto
QPI/DRAM Voltage - Auto
IOH Voltage - Auto
IOH PCIE Voltage - Auto
ICH Voltage - Auto
ICH Voltage - Auto
DRAM Bus Voltage - 1.66v
DRAM DATA REF Voltage on CHA - Auto
DRAM CTRL REF Voltage on CHA - Auto
DRAM DATA REF Voltage on CHB - Auto
DRAM CTRL REF Voltage on CHB - Auto
DRAM DATA REF Voltage on CHC - Auto
DRAM CTRL REF Voltage on CHC - Auto
Load-Line Calibration - Enabled
CPU Differential Amplitude - Auto
CPU Clock Skew - Auto
CPU Spread Spectrum - Auto
IOH Clock Skew - Auto
PCIE Spread Spectrum - Auto[/font][/font]