crossfire issue

[Hammo1]

hey guys just have a question when I run crossfire with 2 x r9 280x vapor x's I am getting an issue as follows the AMD driver has faild but recovered so what I have done is taken the second card out and testes them one by one and cannot seem to get it to fault the issue was happening when I had a game open and was running you tube in the background it would fail but now with one card at a time it seems to be no issues at all with either card any suggestions ?

 

[barnsley]

We'll need a bit more info.

What driver are you running and what are your full specifications for starters?

 

[Hammo1]

ok I have an asus z97-a mobo I have a corsair ax860i psu i5 4690 chip was running 14.9 catalyst 16gig ram

 

[paulstung]

Have you tried the cards in different pci slots ?

 

[KING_OF_SAND]

Did you driver sweep the old driver?

 

[Hammo1]

yes iv done both i just took other card out and it runs fine i go put it back into crossfire and the amd error again sighh...

 

[Thelosouvlakia]

I know that the issue happened when clocks were not syncronised. Can you check that with Sapphire Trixx?

 

[NeverBackDown]

I didn't see this clarified but did you ever test both cards? That is test 1 by itself, if pass, then test the other by itself?

Also make sure Xfire is enabled in CCC.

 

[Tolemac]

I had that issue when I used to run crossfire I think its just a driver bug :huh:

 

[BigDaddyKong]

You were not running one of the 14.9 beta drivers are you? There are a ton of people having problems with crossfire and the beta.

Also, how did you remove the previous driver, or did you install over top of it without removing?

 

[NeverBackDown]

You need to update your CCC suite for 14.9/14.9.2 to work. Otherwise you're getting half the driver installed since the suite contains many of the other things your drivers need.