Can't get my mach usb to work

[Podman]

I have just set up my mach Mach II r507 on my board. Powered her up waited for her to reach those lovely Minus 70 temperatures. Booted her up and let it sit in the bios for a little while monitoring the temps. Chip was showing - temps in Bios (thought that would confuse it !) an dthe prommie said -72 on the front. All seemed well. Booted up into windows and waited till everything had loaded, then plugged the usb lead into the motherboard of my DFI Nforce 4 SLi DR but nothing. What might I being doing wrong ? I put teh leads in exactly the same order as my other case usb connectors.

Anybody got any ideas ?

 

[fatty]

Make sure the lead in your prom is connected then also make sure it is connected the right way round if you ope the prom case with your evap head and all the leads comming out look at how the usb lead is connected the black lead shoud always be the last one as you look into the prom case ie white,green,red,black in that order

 

[imported_Tim]

Yup, I had the same thing.

You'll have to switch to 'onboard USB1.1' in your bios in stead of 'onboard USB2.0'

Then it will work at least mine did