Bay RES???Hmmm...

[| raVen |]

Hello people
I'm planning to upgrade my build a little, just small aesthetic changes.
And I'm thinking about Bay-RES, but I never used one before, so I think that its always worth to try something new. I heard a lot of people saying that bay-res is hard to bleed, but if you put tube res as I did in my build it takes ages as well to get all of the air out anyway. I will need 2-bay res, but I'm not sure which one to get it.
Thanks for suggestions

 

[Bartacus]

Are you *just* looking for the res, or are you looking for a res/pump combo?

 

[Deejeta]

not hard to bleed at all.
my d5 is with a xspc bay res. whenever i clean the loop it only takes a few hours to completely flush out any bubbles.
i just leave the cap off and let it run & top up the fluid occasionally.

 

[| raVen |]

Im looking just for res, cus there is not any good one that supports ddc and I have 2 of them, and since they still work Im not planning to change them to d5's as long as they working.
I just had a look at Ek spin bay res, but that thing makes to much noise.

 

[darkxmen]

monsoon just released a new one.http://www.performance-pcs.com/cata...=37664&zenid=04f5796d8d022309748f839ff56b7e70

 

[tinytomlogan]

Bay res & DDC's = vibrations

 

[Greenback]

I have an xspc bay res with ddc and it's silent once all the air is gone it's just a pain to bleed