tc_overclocker
New member
So all the kit is together... all running nicely... I started the water cooling loop for the x800Pro last night, but has a few teething troubles with a broken pump and my stupid idea of adding a fill line (terrible for bleeding the system).
Now unfortunately the locks do not work on my board, so I reckon I'm limited to about 225FSB, which isn't too bad as this wasn't going to be a hardcore benching rig, as I wanted it as my full time rig as well that I did all my gaming and work on. Saying that, you can be sure that as soon as they release an nForce3 over here, I'll be buying it to replace this one... and then a 3500+ to go in this board
.
The x800Pro, using ATiTool will clock to 560/570 without a single artifact... now I don't know whether this is good or not due to not seeing much about the clocking of them.
So I think I'll be bringing the rig home this week so I can work on it till the early hours of the morning and get this water loop in and all the cable tidying done.. and piccies will follow...
Now unfortunately the locks do not work on my board, so I reckon I'm limited to about 225FSB, which isn't too bad as this wasn't going to be a hardcore benching rig, as I wanted it as my full time rig as well that I did all my gaming and work on. Saying that, you can be sure that as soon as they release an nForce3 over here, I'll be buying it to replace this one... and then a 3500+ to go in this board
.The x800Pro, using ATiTool will clock to 560/570 without a single artifact... now I don't know whether this is good or not due to not seeing much about the clocking of them.
So I think I'll be bringing the rig home this week so I can work on it till the early hours of the morning and get this water loop in and all the cable tidying done.. and piccies will follow...
