3 Pin Y adaptor

[mastering3d]

HI

I have push pull config in my system and have 3 of the Y adaptor

so that i can use all six fans ,Which are 1500RPM but my problem here is this as you can see in the image one 3 pin plug only came with two wires on one side so i rewired that with another yellow that was missing on all 3 sets ,But when all is pluged in the pc and running on the fan control i am only getting 1350rpm ,

Why would the speed drop like that any idea ? ..

Thanks

 

[PeterStoba]

Two fans off one channel only needs one yellow RPM sensor wire.

 

[mastering3d]

i see ok thanks for clearing that up for me so if i take the wire back off i should get full speed again .