Zu Machen!
- Thread starter NoL
- Start date
.
Filters in horizontaly, should work very basically within the shells of the lian li case. I'm going to be using the controller differnetly.
Fact:
1) The mach controllers suck it
2) Controller suck it
3) Who really wants a controller?
So I'm going to maybe use the controller for temp reading and fan control and thats it, but have the unit on a power on/off switch.
Fact:
1) The mach controllers suck it
2) Controller suck it
3) Who really wants a controller?
So I'm going to maybe use the controller for temp reading and fan control and thats it, but have the unit on a power on/off switch.
Completely insulated as well as charged and its in the tuning process!
Best temp I saw last night was -35C @ 165watts, but so far have yet to re-acheive that. I'm more concerned at the moment about proper compressor cooling. The desuperheater coil on this thing is burning hot, and the condenser's quite warm. R507/Isceon89 in the unit and I gotta say thats quite a blend.
I've got a few ideas for further unit mods along the lines of cutting up a spare condenser for a primary desuperheater line.
Pics arriving in the next few days as I am fighting camera trouble.
Best temp I saw last night was -35C @ 165watts, but so far have yet to re-acheive that. I'm more concerned at the moment about proper compressor cooling. The desuperheater coil on this thing is burning hot, and the condenser's quite warm. R507/Isceon89 in the unit and I gotta say thats quite a blend.
I've got a few ideas for further unit mods along the lines of cutting up a spare condenser for a primary desuperheater line.
Pics arriving in the next few days as I am fighting camera trouble.
Yeah most systems running straight r410a (which is way to high pressure for 120mm condenser) run around -38C evap load. -35C load @ 165 watts, and -31.5C load @ 190 watts is quite awesome. I love the unit and i think i need to get recutting on the window and then respray the panels somehow. The paint on the left n rights pretty bad, but the fronts fine. I also need to rehook up that controller and see if it will read the probe on the evap.
Okay update, trimmed the cap tube, picked up some double sided tape for the panels, and we'll see how that holds (Thats what they supply originally after all) and I've retuned. Currently holding -33C or so @ 165watts of heat and I'll let it run all night or so under these conditions. If not hotter loads.
Here's some updated pics, and I'm currently searching for one of the bars that holds on the panels. (one of them has seemed to run away.)
Here's some updated pics, and I'm currently searching for one of the bars that holds on the panels. (one of them has seemed to run away.)
hehe
