what best for a cooling loop

[OptimAdam]

Hi just want some advice.

I have a pump that pumps to the res, out the res it then splits on going to the cpu and another to the gpu.

I want to know if i should rejoin the loops before the rads and go though them both. Or go throught them both and then rejoin?

How will reach on affect cooling if anything at all?

flow rate?

 

[Luigi]

well i would change your loop completely. the res should be the last thing in you loop, not the first. and dont run block in paralel, the water will normall go the easiest route to one component will get less cooling...

So therefore run them through both rads

 

[OptimAdam]

The tubing not the same size btw. it gets smaller when it splits so it has to go both ways.

There such a restriction from the cpu and gpu black that it has to go both ways.

 

[Luigi]

well its still not optimal.

 

[OptimAdam]

ye you where right.

 

[Golden Dragoon]

In my opinion (and I have tried various ways in the past) the best order for any loop is this:

Res> Pump> CPU\GPU> Rad> Res