Project: MNU by Kylevdm - Sponsor Update "Hello TM3!!!"
After a yearlong hiatus, I am back to modding! That is right you did just read that... I have had a number of issues with modding this year: time, money, health, school, etc, etc. Now that most of that has been cleared out of the way I can finally get back to modding. This project I have been planning for close to 4 months while doing other things for The Mod Brothers and Case Mod Blog. I have finally ironed out the concept of what I want this case to look like and it is going to be based on the awesome movie "District 9". Bill Owen has been creating a District 9 mod as well which I am sure you are all familiar. However, I am going to be taking a slightly different side to the story. My mod is going to be a MNU General Purpose Security Vehicle. When speaking to Bill he sent me over this picture that he had found while researching for his project.
Original Artists (WETA)
The MNU used this General Purpose Security Vehicle in the movie, and so I am going to be incorporating bits and pieces from the design of the double cab into a case.
A few sketches...
And finally we get to the case. It is, well to be honest I have no clue! Branded as a MECER PREMIUM-X it is an old AT case as far as I can make out but that is all about to change.
As you can see, it is in fact missing a side panel. So while going through all my scraps of aluminium from my last Project: Deadline I found this and it was MADE for this case! Look at that it fits perfectly!
Well not quite perfectly but pretty much I just need to trim the top a bit. I marked it up with some masking tape and drew the line in. Just remember to measure, measure, and measure again! Will get it cut tomorrow before the New Year PARTAAY!
After a yearlong hiatus, I am back to modding! That is right you did just read that... I have had a number of issues with modding this year: time, money, health, school, etc, etc. Now that most of that has been cleared out of the way I can finally get back to modding. This project I have been planning for close to 4 months while doing other things for The Mod Brothers and Case Mod Blog. I have finally ironed out the concept of what I want this case to look like and it is going to be based on the awesome movie "District 9". Bill Owen has been creating a District 9 mod as well which I am sure you are all familiar. However, I am going to be taking a slightly different side to the story. My mod is going to be a MNU General Purpose Security Vehicle. When speaking to Bill he sent me over this picture that he had found while researching for his project.
Original Artists (WETA)
The MNU used this General Purpose Security Vehicle in the movie, and so I am going to be incorporating bits and pieces from the design of the double cab into a case.
A few sketches...
And finally we get to the case. It is, well to be honest I have no clue! Branded as a MECER PREMIUM-X it is an old AT case as far as I can make out but that is all about to change.
As you can see, it is in fact missing a side panel. So while going through all my scraps of aluminium from my last Project: Deadline I found this and it was MADE for this case! Look at that it fits perfectly!
Well not quite perfectly but pretty much I just need to trim the top a bit. I marked it up with some masking tape and drew the line in. Just remember to measure, measure, and measure again! Will get it cut tomorrow before the New Year PARTAAY!
.
me and him are good friends he co-hosts my podcasts with me 
Both cases were MEANT to be finished at the same time but I just did not have to time!
