Phanteks Enthoo Primo

[S_I_N]

its really nice to build in with one minor thing lol. I learned the hard way. Before you start plumbing your water and have the cable cover on, put your sata cables on the mobo. As I normally leak test with only whats needed for the loop(s) Ididnt have my sdd's or hdd's installed yet. And when it came time to cable it up I had one helluva time getting the sata cables plugged into the mobo.

 

[dodo21x]

PS can you link me your gallery ?

 

[S_I_N]

I did not do a log for this build as I just moved components to it and replaced my tubing I'm going to redo it soon with new rigged tubing and then I may make a log

 

[dodo21x]

Can't wait to see it

 

[S_I_N]

ok heres the pics I said I'd do lol Changes planned are swap out the dual bay dual d5 rez for a tube rez and single d5 and most likely going single loop. Add another rad to the case to allow even lower rpms on fans even though the ones I have are quiet on the speed there at. Also with the change will be rigid tubing for a cleaner look (hopefully). Still need to check with my bios and see how I can make the fans ramp up under load. the settings I've seen are a tad greek so gotta research that. But anywho on the the pics. Also sleeve those damn red wires.





I now cable management is a bit lax but I wanted to get it back up and running quickly.


For those with long gpu's like me heres a pic of how I made the cover for the rez bracket work. I held it in position where it would bolt in and marked it with a sharpie then notched the plastic with my dremel. Kinda like a gpu support now lol. But I think it looks better in the case versus some builds I've seen where they either leave out the bracket or leave the plastic part off showing the holes.

 

[dodo21x]

The next step is to change the fans, BQ don't mach anymore (i think) and i have no idea what to buy :/