Overclocking Problems

[LiViNgL@RgE]

Hi y'all,

I've got a A64 3400 CH, which does 2772Mhz Under my mach 1, i've just got a Mach II GT from Phil, I install the drivers, upgraded firmware with mach II stood next to my existing setup.....

Now the system doesn't make it to windows, I get a BSOD saying "IRQ NOT LESS THAN" which I always when the CPU is clocked too high or there is a Vcore droop, the mach II is disconnected but the drivers are still installed & thats the only thing that has changed in the system.....

I know the systems stable ran MemTest 2 Hours - 2000% Coverage, SuperPI 1Mb, 2Mb, 8Mb, 16Mb & 32Mb, 3DMark 01 - 50 Loops of each test, CPU Burn-In - 12 Hours but prime fails within 10 seconds!

Could the drivers cause this?

Cheerz For Your Help

 

[LiViNgL@RgE]

Hi Y'all,

Found the problem my Audigy's gone up S*** Creek! 13 Months old, Typical

So back to onboard, the lovely hissing and popping!

Cheerz

 

[Wingz]

i'm glad you got it sorted

have your tried clocking it higher with the Mach GT?

 

[LiViNgL@RgE]

have your tried clocking it higher with the Mach GT?

No mate this is the max without more Vcore.... Going to have the board modded, Vcore & Vdimm........

The memory's crying for more volt's too, 265Mhz @ 2.8V just don't cut the mustard with me.... Gonna chuck 3V at it Hoping for 280 1:1?

Thanx