new watercooling setup need some input

[grim]

ok here is what i have now the temps on air were high i think now the temps verry on what program i use speedfan.core temp and gigabytes easytune the temps below are what i seen in easytune i am new to watercooling this is the first system i have done and am not sure if these temps are right. Any help would be great and thanks in advance.

air temp at idle

cpu 50-55°c

gpu 60-70°c

water cooled temp

cpu 35-50°c

gpu 51°c

gigabyte GA-P35C-DS3R rev 1.1 mobo

q6600 cpu

8800 gts card

ddr2 crucial balistic memory

this is the watercooling part

Swiftech Apogee GTX APOGEE-GTX

Extreme Performance CPU

Water Block (1/2" barbs)

Laing D5/Swiftech MCP655 MCP655

12 VDC Sealless Leakproof

Water Pump w/ Flow

Control (1/2" barbs)

FLXP00 Fluid XP+ EXTreme Options: Bottle Size: 32 Ounce Bottle

FPRES Fillport Reservoir Options

2 of these

HARDWARE LABS BLACK ICE® GT STEALTH 120 RADIATOR (1/2" BARBS)

 

[darkorb]

i believe they are right, not 100% though.

i just noticed in ur pic, u have a huge kink in ur WC loop, right near the PCI slot, its almost bent like, 180 degrees, defff gotta fix that.

 

[markkleb]

you DEFINATELY need to cut out the center where the rad is bolted, also the exhaust fan in the top.

Also that kink in the hose is BAD!

by the way thanks for the picture (it helps a LOT)

 

[grim]

the kink in the bottom is the drain line i installed i can post dif pics if needed now i have 2 fans on both rads should there be only one

 

[markkleb]

the kink in the bottom is the drain line i installed i can post dif pics if needed now i have 2 fans on both rads should there be only one

There is nothing wrong with 2 fans per rad, but if you get rid of the blockage (small holes) 1 fan will work a LOT better than how it is now.

Those little holes punched out block over 50% of the air that is supposed to exit the case. The air backs up and just swirls around building more heat.