The actual water cutting cost me £20 the guys were only presented with a couple of JPG's and did all the AutoCAD work themselves, I was expecting a much bigger bill so they might have done me a favour.
There is a tolerance of I think he said 3mm but you wouldn't have known from the finished product as some of the lines have seriously sharp angles on them, apparently they get through a sapphire focuser every couple of weeks and the machine eats nozzles at a rate of 1 a week.
They asked for pictures once the projects finished and handed over, so when I send them over I will ask how they feel about doing similar kind of work.
There is a tolerance of I think he said 3mm but you wouldn't have known from the finished product as some of the lines have seriously sharp angles on them, apparently they get through a sapphire focuser every couple of weeks and the machine eats nozzles at a rate of 1 a week.
They asked for pictures once the projects finished and handed over, so when I send them over I will ask how they feel about doing similar kind of work.