New OCZ Reaper!!

[Bondi007]

Just got some new memory the OCZ Reaper 6400 memory at CL4 ( 4-4-4-15 ). Any body else got this ram?

Cheers :worship:

 

[Jeddy]

I do and it clocks really well!

2.1v i had 880mhz @ 3-3-4-11 2t

but i prefered tighter timings

 

[Bondi007]

Lol nice im going to overclock the whole system just need decent cooling on teh other parts

 

[Fake]

I have the same RAM and it refuses to post at 840MHz with 4-4-4-15 timings even with 2.2V. Yet it can do over 1000MHz easy on 5-5-5-18 timings. I think it may be my motherboard. I've been having problems with it ever since I got it.

 

[Ghosthud1]

would anyone recommend this ram because im just about to purchase some, they got low temps etc?

 

[Bondi007]

They are great memory and should be able to clock well but I havnt tired with mine.

 

[Fake]

Yea mate excellent RAM. I think my problem is a crappy motherboard, Can't say I'll be using another Gigabyte motherboard again after I ditch this one and go back to Asus.

 

[|3ourne]

I have the same RAM and it refuses to post at 840MHz with 4-4-4-15 timings even with 2.2V. Yet it can do over 1000MHz easy on 5-5-5-18 timings. I think it may be my motherboard. I've been having problems with it ever since I got it.

not your motherboard. Its the ICs the ram uses. The microns like higher volts , the elpida H ICs do not. However 5-5-5-18 at higher mhz will definitely help out if you are on an intel platform compared to lower timings. Not a bad set by any means , just not one for tight timings.

 

[Fake]

not your motherboard. Its the ICs the ram uses. The microns like higher volts , the elpida H ICs do not. However 5-5-5-18 at higher mhz will definitely help out if you are on an intel platform compared to lower timings. Not a bad set by any means , just not one for tight timings.

I read a review of the OCZ Reapers and they got there's to 930MHz at 4-4-4-15 timings so I was a little disappointed that I was almost 100MHz less then them. It's either the RAM or motherboard that's not allowing me to clock higher then 4085MHz on the CPU and I don't think it's the RAM:nono: Although for some reason it won't let me clock past 1080MHz stable anymore Can only do it for benching.

 

[|3ourne]

the earlier versions did have micron ics in them. But the manufacturers starting price gauging them and since the reapers are middle of the lineup , they get the second rate Elpida ICs. Seriously though , they are really not bad. They last longer , run cooler and need less volts. Microns are really finicky and tempramental . Kinda like the difference between a cute girl next door and a hot crazy hot blooded italian senorita .