very nice mate. I think your idea of the PSU pulling cold air from underneath the case is a good one, but I don't see how you can hide the cable if the PSU is that way round and facing the front of the case, unless you set it back say 3cm and just run the cable through a hole underneath the case.
My watercooled Stacker 831 build :)
- Thread starter inonefly
- Start date
I took them out so I can cut the case to mount the PSU properly, that night my gf wanted to watch movies using the projector so I put everything on the mobo tray on the table and used a screw drivers to short the power on pins(was too lazy to get the power buttom/cable from the garage). i got a spark when i tried to power it on, but it did powered on a few sec then shut off completely, and i cant get it to post anymore 
I'll never power up my pcs with a screw driver!
anyway, look at the bright side, I can get a new mobo, im thinking a DFI LT P35/X38 or maybe the new P45 Asus P5Q DLX (and thats 16 phase cpu power
). I also take the opportunity to upgrade the cpu block to a D-TEK FuZion V2 
I'll never power up my pcs with a screw driver!anyway, look at the bright side, I can get a new mobo, im thinking a DFI LT P35/X38 or maybe the new P45 Asus P5Q DLX (and thats 16 phase cpu power
). I also take the opportunity to upgrade the cpu block to a D-TEK FuZion V2 
rick_man_allen
New member
nice case put more pics up of it with all the parts installed looks nice
rick_man_allen
New member
looking good mate =)
Finally got the new mobo delivered with the MIPS blocks, thanks a lot clone38
I've decided to seperate the NB/SB/Mosfet from the loop since the last install's temp wasnt satisfying. Will be adding a new loop for them after I finished my other build. Here's the finished build for now Still need to add a mesh at the back , where the orignal PSU mounting plate is.
Some night shots,the coils are more vivid green in real, i dont know how to take pics for the uv glow in dark, tried a few setting with no luck, this is the best i can get.
Here's the MIPS nb/sb/mosfet blocks, I'm thinking of getting another DDC and a RS240 or 360 for them, will decide when the reviews of the RS come out.
This is my first try on cable management, took a lot of time but still not as clean as I want. Any comments/suggetions welcome.
I've decided to seperate the NB/SB/Mosfet from the loop since the last install's temp wasnt satisfying. Will be adding a new loop for them after I finished my other build. Here's the finished build for now
Still need to add a mesh at the back , where the orignal PSU mounting plate is.
Some night shots,the coils are more vivid green in real, i dont know how to take pics for the uv glow in dark, tried a few setting with no luck, this is the best i can get.
Here's the MIPS nb/sb/mosfet blocks, I'm thinking of getting another DDC and a RS240 or 360 for them, will decide when the reviews of the RS come out.
This is my first try on cable management, took a lot of time but still not as clean as I want. Any comments/suggetions welcome.
