So weird thing. I was adjusting my voltages because was starting to get BSOD using Powerdirector 12 video editting software. then I found out its an issue with the program. During stress testing I noticed my voltages jumping from the set 1.18V to 1.26 in OCCT. I went in to turn off adaptive and set it to manual. Then i realized while in manual mode it won't let me adjust the voltage, only in adaptive? I went through the guide again and for the love of me can't figure out what I am missing? Am going to go through TTLs video again and see if I can figure it out, but some of the stuff is hard to find because I am using asus' bios and not msi, they are close but some differences. any quick things I may check before I go at it again?
manual and adaptive voltage
- Thread starter kbalaz
- Start date
