just started overclocking .. ive been using n-tune for my nvidia graphics card .. all was well and got some half decent results for the GPU and CPU BUT .. on the last run i had reached the max and it went choppy (all previous settings worked fine) .. so i restarted and lowerd the settings down .. i then re-tried the checker to see if the choppyness had gone .. but it had not.
retarted pc again .. but after around 1min10 - 1min30 it freezes .. 100% (this is my 2nd pc .. that how im able to come online and type this)
from what i can remember i got the settings to (and made them start when windows did)
CPU 200MHz factory got them to 248MHz (250MHz was as far as the bar would go)
GPU core bus (what ever the 8600GT is factory) to 668MHz
Memory bus (what ever it was factory) to 867MHz
they were the last saved settings and they did work .. until i tried higher (did not save) and then tried to lower them below what i saved ...
how am i going to reslove this problem? i was thinking of re-installing XP from my boot cd .. would this work ? or is there a way from the BIOS to change it back ?
retarted pc again .. but after around 1min10 - 1min30 it freezes .. 100% (this is my 2nd pc .. that how im able to come online and type this)
from what i can remember i got the settings to (and made them start when windows did)
CPU 200MHz factory got them to 248MHz (250MHz was as far as the bar would go)
GPU core bus (what ever the 8600GT is factory) to 668MHz
Memory bus (what ever it was factory) to 867MHz
they were the last saved settings and they did work .. until i tried higher (did not save) and then tried to lower them below what i saved ...
how am i going to reslove this problem? i was thinking of re-installing XP from my boot cd .. would this work ? or is there a way from the BIOS to change it back ?
