Update time again!
I drained the off coloured EK liquid out of the loop and filled the entire loop up with distilled water, I ran this in there for about an hour before draining that out. There was still a fair amount of off coloured liquid clinging to the internals of the parts. So I made up the Mayhems blitz kit solution. Wearing gloves and eye protection (This stuff is pretty nasty) I poured it into the loop. I filled the reservoir to about half way as the Mayhems blitz kit has a tendency to froth up quite a lot and started the system going. I moved the pump to a few different settings over the course of the 24 hours of cleaning.
One thing which I wasn't expecting was to find flakes within the filter! This shocked me quite a bit, however after doing a little reading this is fairly common with some copper radiators. None the less, I needed to take the loop apart once the blitz kit was done doing its job so that I could have a look at all the blocks. I didn't get and photos of the blocks but they were actually completely clean to my surprise!
Here is a more detailed look at the RAM/ CPU bends which the Mayhems Blitz kit running through them! Hopefully its going to make a decent difference to the overall look!
Here is another shot taken later on that day, you can see that it looks to of gotten even misty-ier which hopefully means most of the crap is getting out of my loop!
After these steps I then drained the Mayhems Blitz kit out of the loop. I then connected a pipe coming from a bucket of water into the loop. This bucket was being filled by my kitchen tap and the water coming out of the loop was going straight down the drain. I ran this for about an hour just to completely flush the Mayhems blitz/ any other crap completely out of the loop to make sure it was ready for the next lot of distilled water!
Here is the loop after I added the distilled water after running the loop with tap water for an hour. Dont worry though, I used Biocide to make sure there was nothing going to grow!
Then next thing to do is to leave it running for a while just to make sure there is nothing further up with the loop as I can easily just add the rest of the remaining Mayhems Blitz kit to the loop if I need to do another clean however after two hours it is looking lovely and clean! Very happy so far!
I have also decided not to use EK's coolant, just in case there is something up with it. When I ordered the Blitz kit, I also ordered some Mayhems Blue Dye which I will be adding to the system to make a super deep blue! However that is for a future update!
I hope as always you have enjoyed this update and it has been able to help anyone out! Please subscribe to the thread for the latest updates! I hope there isnt too much left to get this system finally completed!
TPK Awwwwwaaaayyyyyyy
