Jack's 600t Ongoing project...(full acrylic side panel)

[andrevautour]

nice work

 

[Concept73]

nice work

Thanks

 

[BPRSM]

Love the PC! How did you get your 24 pin power and PCI power cables to stay in such a perfect position?

 

[Concept73]

Love the PC! How did you get your 24 pin power and PCI power cables to stay in such a perfect position?

I did it by "Training the cables" for about 30 mins just bending the paracord cables into position and holding them there!
Sounds boring but i just put a film on, and held them there, works for pretty much all cables, if not you can try it with cable ties and doing something similar!
Hope that helped!

 

[BPRSM]

I did it by "Training the cables" for about 30 mins just bending the paracord cables into position and holding them there!
Sounds boring but i just put a film on, and held them there, works for pretty much all cables, if not you can try it with cable ties and doing something similar!
Hope that helped!

Okay I'll try that thankyou

 

[Glassjaw003]

I did it by "Training the cables" for about 30 mins just bending the paracord cables into position and holding them there!
Sounds boring but i just put a film on, and held them there, works for pretty much all cables, if not you can try it with cable ties and doing something similar!
Hope that helped!

I like how you had so much attention to detail with the cables. Not just in the look, but the actual placement. In the first picture the cables going to the graphics card come out of it and kind of bend to get out to the back of the case, while in the current build they are just bending down and straight out. I've seen a lot of builds that keep it like yours was in the first picture, and it is a bit annoying. Although for some cases it can't be helped.

Again, good job.

 

[Concept73]

I like how you had so much attention to detail with the cables. Not just in the look, but the actual placement. In the first picture the cables going to the graphics card come out of it and kind of bend to get out to the back of the case, while in the current build they are just bending down and straight out. I've seen a lot of builds that keep it like yours was in the first picture, and it is a bit annoying. Although for some cases it can't be helped.

Again, good job.

Ahh thank you! yeah my first cables were about £10-£15 from a ebay shop, nothing special, so i bunged them in, however the cables i currently have are custom made FOR ME by my freind and i they look amazing so i wanted to take the time to make sure they were positioned properly!

But i totally agree! the small things can really make a build!

 

[Overclocker55]

Love It

 

[Cody_h4x]

hahah you got one of those tikis , Looks clean the 600t looks so different with that white grill up top

 

[Concept73]

hahah you got one of those tikis , Looks clean the 600t looks so different with that white grill up top

Haha yeah got from an Iseries LAN,
and thank you! i am very proud of the finish it has

 

[Concept73]

Love It

Cheers